Feed a center-fed wire dipole from coax
A balanced wire dipole and an unbalanced coaxial feed line behave differently at their junction. The GRA-BA2000 provides a 1:1 current-balun interface at that feed point. Use it when building a home-station wire dipole, replacing an existing dipole center feed, or assembling a temporary inverted-V with a center support.
Connect the wire legs and feed line
Connect one wire leg to each balanced terminal. Fit a PL-259 male plug on the 50-ohm coax to the balun’s SO-239 female input. Support the coax separately to relieve connector strain. For an outdoor installation, protect the mated connector from moisture using a method appropriate for your feed line and site.
Check the band and SWR at the installed height
The balun covers 0.5–60 MHz, including the 6-meter amateur band. Choose wire lengths and an installation geometry that suit your operating band. The 1:1 ratio preserves the impedance ratio. Final SWR depends on the antenna, its surroundings, and the feed line. Check it with an analyzer or at low power before increasing transmit power. A 144 MHz 2-meter dipole requires a balun rated for that band.
Specifications
| Specification | Value |
|---|
| Model | GRA-BA2000 |
| Type and ratio | 1:1 current balun |
| Frequency range | 0.5–60 MHz |
| Nominal feed line | 50-ohm coax |
| Coax connector | SO-239 female, mates with PL-259 male |
| Power | Up to 2,000 W peak envelope power (PEP). For continuous or high-duty-cycle modes, use a separately verified rating. |
| Package | One GRA-BA2000 current balun |